Assembly to hold only one lens.
Assembly to hold two lenses.
 |
Lensholder fits INON and Ultralight lattice-arm sections, or
any bar 10mm x 25mm cross section with midline hole or cutout
larger than 5mm.
Assemble as per appropriate illustration above.
Do not use excessive force when tightening retaining bolt.
For INON arm: Tighten just sufficiently
to clamp arm without sliding or movement.
For Ultralight arm: Due to 1"
(25.4mm) maximum width of arm bar, lensholder is a tight fit.
Press lensholder disk and back retainer (if used) into place
while maintaining fixing hole alignment. Tighten retaining bolt
just sufficiently to clamp lensholder onto bar. |
|
